Make sure you match the correct size when replacing with commercially available hardware. Step 3 - Remove Body Screws Remove all the body screws holding any outer casings and the top in place. Make sure to rinse it thoroughly and set it in a safe place to dry. Step 2 - Remove and Clean Tray Take out the bug catcher tray located on the bottom of the device being careful if it is full not to spill the contents.ĭispose of the dead bugs properly and clean the tray using warm water and a mild detergent. Place a piece of masking tape over the switch to alert anyone not to trip it. ![]() If it is part of a hard-wired system, locate the circuit breaker that powers the device and turn it off. Mosquito Shield Bug Zapper Driver To Discharge.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |